Publicité
EN
WIRELESS ELECTRICAL ROUTING
1 - To assemble the frame, it is preferable to hold
it by the seat post at a torque of 7 Nm. Initially, the
frame should be bare to facilitate access through the
headset and bottom bracket, allowing you to place
the rear disc brake hose. Use foam tubes of 510 mm
length for each brake hose to limit noise in the down
tube.
2 - It is advisable to route the rear brake hose through
the left rear dropout, then to the bottom bracket, and
up the down tube to finish in the headset, as done
in previous versions, passing through the upper
bearing and then into the spacers.
3 - Similarly, for the fork, the front brake hose should
pass through the hole on the headset pivot and exit
at the fork leg. If the brake caliper is pre-routed with
its hose, pass it through the hole at the fork leg and
exit through the opening of the fork pivot.
4 - Following the manufacturer's recommendations,
install the groupset.
5 - Place the plugs in the mechanical cable entries.
6 - Finalize your assembly.
EN
Publicité
