Publicité
EN
EN
MECHANICAL ROUTING CONFIGURATION
INSTALLATION ROUTING
1 - To assemble the frame, it is best to hold it by the
seat post at a torque of 7 Nm. Initially, the frame
should be bare to facilitate access through the
headset and bottom bracket, allowing you to place
the cables in the down tube and then the guide (Fig.
1) to the front and rear derailleurs and the rear disc
brake. Use foam tubes of 510 mm length for each
cable and brake hose to limit noise in the down tube.
2 - First, take the derailleur cable that will run from the
rear right dropout through the bottom bracket guide,
then up the down tube to reach the handlebars,
passing through the headset around the fork pivot
and through all the components of the headset (Fig.
1), including the upper bearing specifically defined
for this purpose.
Publicité
