Publicité
EN
2. Pull the garment which is to be pressed over the balloon and do up the zip or buttons if
necessary. Make sure that
○ the legs of the balloon fit properly into the legs of the trousers and are not twisted or
scrunched up,
○ all buttons on the garment (including the legs) are done up.
3. Spread the clamps along the bottom of the garment (at the front and back in each case
on the outsides) so that it is weighed down and will not go out of shape when the bal-
loon is inflated.
4. Insert the mains plug into an easily accessible socket.
5. Turn the timer (7) clockwise and set it to the length of time you want. Each LED light
represents 5 minutes.
6. Once the balloon has inflated, straighten out the garment and smooth it down again.
7. Remove the garment from the balloon after the completion of the drying/pressing
process.
8. Pull the mains plug out of the plug socket and allow the device to cool down completely.
Tips
•
The device is intended primarily for machine-spun laundry! If hand-washed or non-
machine-spun laundry is to be pressed, first allow it to dry out a little first.
•
The drying / pressing process takes around 10 minutes for a spun-dried shirt or
trousers. However, the length of time can vary depending on the material and thick-
ness of the material. We recommend that you start with a shorter time and extend it if
necessary.
•
The balloon can be enlarged or reduced in size with the aid of the zip fasteners. For
smaller sizes, the zip fasteners should be closed. For larger sizes, the zip fasteners should
be opened on both sides.
•
Wide-apart buttons may result in the button strip crimping slightly during pressing.
Here it is advisable to smooth down the button strip again by hand immediately after
the pressing process.
•
In the case of trousers with a very small waist it may not be possible to pull them over
the attachment when it has already been fitted. In this case you proceed as follows:
○ push the balloon (12) upwards slightly, to enable access to the rods (13),
○ remove one of the two rods from the Y tube once more (11),
○ draw the trousers over the two rods,
○ now replace the rods in the Y tube and
○ draw the balloon over the mounting flange on the main device again.
•
After the drying / pressing process any creases need to be ironed out using a normal
iron.
20
07252_12315_14907_DE-EN-FR-NL_A5_V7.1.indb 20
07252_12315_14907_DE-EN-FR-NL_A5_V7.1.indb 20
30.04.2024 12:39:25
30.04.2024 12:39:25
Publicité
