Publicité
DEVICE OVERVIEW
10
9
8
7
13
ASSEMBLY
Presser for blouses and shirts
1. Plug the telescopic rod (2) into the recess on the top of the motor unit (5).
2. Place the hanger (1) onto the telescopic rod (2). When you do this, make sure that the
slight bend in the hanger (1) points forwards.
3. Check that the drip protection (3) is fitted securely on the telescopic rod. The drip pro-
tection must be fitted approx. 15 cm above the fan outlet. It prevents any water that
may drip down from being able to get into the fan (4). Make sure that the drip protec-
tion is not fitted any lower to prevent a build-up of heat in the fan.
4. Attach the balloon:
○ Pull it over the hanger. When you do this, make sure that the side with the hole line
points forwards.
○ Pull the small elastic cord at the top over the collar section (10) on the hanger.
○ Pull the large elastic cord at the bottom over the mounting flange (8).
The device is disassembled in the reverse order.
07252_12315_14907_DE-EN-FR-NL_A5_V7.1.indb 17
07252_12315_14907_DE-EN-FR-NL_A5_V7.1.indb 17
1 Hanger
2 Telescopic rod
1
3 Drip protection (premounted on the
telescopic rod)
4 Fan
2
5 Motor unit
6 Ventilation slots
7 Timer (5 – 30 minutes)
3
8 Mounting flange
9 Clip (for adjusting the height)
10 Collar section
4
5
6
11 Y tube
12 Balloon
13 Rods
11
12
30.04.2024 12:39:21
30.04.2024 12:39:21
EN
17
Publicité
