Publicité
5. Insert the mains plug into an easily accessible socket.
6. Turn the timer (7) clockwise and set it to the length of time you want. Each LED light
represents 5 minutes.
7. Once the balloon has inflated, straighten out the garment and smooth it down again.
8. When the set time elapses, the device switches off automatically. The drying / pressing
process can be interrupted at any time by turning the timer to the starting position.
9. Remove the garment from the balloon and hanger (1).
10. Pull the mains plug out of the plug socket and allow the device to cool down completely.
Presser for trousers
07252_12315_14907_DE-EN-FR-NL_A5_V7.1.indb 19
07252_12315_14907_DE-EN-FR-NL_A5_V7.1.indb 19
2. If you have not already done so, pull on the balloon (see the
"Before Initial Use" chapter, "Assembly" section).
L
The balloon should sit immediately below the mount-
ing flange (8) so that it can fully inflate.
3. Pull the garment which is to be pressed over the balloon
and the hanger (1) and do up the buttons if necessary.
Make sure that
○ the collar is fitted over the collar section (10) on the
hanger,
○ any button strip is over the hole line on the balloon,
○ the arms of the balloon fit properly in the sleeves of the
garment and are not twisted or scrunched up,
○ all buttons on the garment (including on the sleeves) are
done up.
4. Spread the clamps along the bottom of the garment (at
the front and back in each case on the outsides and in the
middle on the button strip at the front) so that it is weighed
down and will not go out of shape when the balloon is
inflated.
1. If you have not yet done so, attach the balloon (2) (see the
"Assembly" chapter).
L
The balloon should sit immediately below the mount-
ing flange so that it can fully inflate.
EN
19
30.04.2024 12:39:25
30.04.2024 12:39:25
Publicité
