Husqvarna DM 230 Manuel D'utilisation page 9

the 110V type of the product without
an isolation transformer, refer to EN/IEC
61558-1 and EN/IEC 61558-2-23. The
isolation transformer must have a grounded
earth wire on the secondary winding side.
WARNING:
water.
WARNING:
product, always do a check of the PRCD.
To examine the PRCD on page
Refer to
9 .
The product has a PRCD installed on the power cord.
The PRCD is for protection and engages if an electrical
Technical data on page 20 for
fault occurs. Refer to
information about at which current the PRCD engages.
The red light shows that the PRCD is on and that the
product can be started. If the red light does not show,
push the RESET button.
To examine the PRCD
WARNING:
type sold in United Kingdom and Ireland.
PRCD on page 8 .
Refer to
WARNING:
examined each time the power plug is
connected to a power outlet.
WARNING:
repaired, always speak to an approved
Husqvarna service agent.
1. Connect the power plug of the product to a power
outlet.
2. Push the "RESET" button. The indicator above the
button is red when the current is connected.
3. Start the product, refer to
page 14 .
1473 - 002 - 08.03.2024
Do not put the PRCD into
Before you operate the
Not applicable for 110V
The PRCD must be
If the PRCD must be
To start the product on
4. Push the "TEST" button. If the product stops, the
PRCD operates correctly.
Isolation transformer
Note:
Applicable for 110V type sold in United
Kingdom and Ireland.
Do not operate the 110V type of the product without
isolation transformer that refers to EN/IEC 61558-1 and
EN/IEC 61558-2-23.
The isolation transformer must have ground wires on the
230V and the 110V side.
Power switch
The power switch is used to start and stop the product.
To do a check of the power switch
1. Connect the power plug of the product to a power
outlet.
9