Husqvarna DM 230 Manuel D'utilisation page 11

CAUTION:
for the drill stand carefully.
To attach the product to a drill stand, refer to the manual
for the drill stand.
• Remove the auxiliary handle when you use the
product with a drill stand.
• Always use a drill stand if you stand on a scaffold
when you drill.
• Make sure that the drill stand is correctly attached.
• Make sure that the product is correctly attached in
the drill stand.
• Use only with approved Husqvarna drill stands.
Refer to Accessories on page 21 .
• Attach the trigger lock bracket. Refer to
trigger lock bracket to the product on page 11 .
To attach the trigger lock bracket to the
product
The trigger lock bracket must only be used when you
use a drill stand. The trigger lock bracket pushes and
holds the power switch to start position.
1. Attach the product to a drill stand. Refer to
the product with a drill stand on page 10 .
2. Turn the knob (A) counterclockwise.
A
1473 - 002 - 08.03.2024
Read the operator's manual
To attach the
To use
3. Put your thumb on the lower part (B) of the trigger
lock bracket and put 2-4 fingers at the top part (C) of
the trigger lock bracket. Push your thumb and fingers
together and install the trigger lock bracket to the
product.
C
4. Turn the knob (D) clockwise to push and hold the
power switch to start position.
D
To use the product handheld
Do not do handheld drilling in first gear (A).
WARNING:
in first gear. The product has a strong torque
that can result in injury if the drill bit stops to
move freely.
1. Install a drill bit with a maximum diameter of 75 mm.
The larger the drill bit, the more dangerous reaction
if the drill stops to move freely.
B
A
Do not do handheld drilling
11