Husqvarna DM 230 Manuel D'utilisation page 12

2. Lock the auxiliary handle tightly in position before
you start to drill. Refer to
in an applicable position on page 12 .
3. During operation, keep a stable position with you
feet on the ground.
WARNING:
ladder. If the drill bit stops suddenly, the
strong torque can cause you to fall.
4. Change the gear to 2 or 3. Refer to
on page 14 .
WARNING:
drilling in first gear. The product has a
strong torque that can result in injury if
the drill bit stops to move freely.
To set the auxiliary handle in an
applicable position
1. Turn the auxiliary handle counterclockwise to
release it.
2. Move the auxiliary handle around the spindle shaft to
an applicable operation position.
3. Turn the auxiliary handle clockwise to lock it. Tighten
fully.
To prepare the product for dry drilling
WARNING:
protection. Do not breathe the dangerous
dust.
WARNING:
vacuum cleaner. Use only dust extractors
made especially for dangerous dust. Refer
Recommended dust extractor capacity on
to
page 21 for specifications.
1. Attach the dust extractor adapter to the product.
12
To set the auxiliary handle
Do not drill from a
To change gear
Do not do handheld
Use approved respiratory
Do not use a standard
2. Attach the dust extractor to the dust extractor
adapter.
3. Start the dust extractor.
To prepare the product for wet drilling
CAUTION:
pressure is not too high. Refer to
data on page 20 .
CAUTION:
water system, use only clean water.
CAUTION:
supply coupling. Speak to your dealer for
more information.
1. Connect the Gardena
valve to the water connector.
2. Open the water system.
3. Set the water pressure to remove all waste material
from the drill hole.
To prepare the product for inverted drilling
WARNING:
with a sealing disc during inverted drilling.
Water that goes into the product increases
the risk of electrical shock.
Make sure that the water
Technical
To prevent blockage in the
Use only an approved water
®
male coupling with water
Always use a slurry ring
1473 - 002 - 08.03.2024