Husqvarna DM 230 Manuel D'utilisation page 17

Maintenance
Make sure that movable parts function correctly and
move freely.
Make sure that the cutting tool is sharp and clean.
Make sure that the PRCD functions correctly.
WARNING:
100-120V type sold in United Kingdom and
Ireland. Refer to
Examine the power cord, other cables, and the power
plug for damage.
Make sure that the handles and holding surfaces are
dry, clean and free of oil and grease.
Make sure that the product is clean.
Examine the shaft seals for damage/water leakage.
Make sure that the nuts and screws are tight.
Make sure that the power switch operates correctly.
Replace the gear oil.
Examine the carbon brushes for damage.
To clean the product
CAUTION:
goes into the motor or the gearbox.
CAUTION:
clean the product.
• Use a dry or moist cloth to clean the product.
• Remove blockage from all air openings. A blocked
air intake decreases the performance of the product
and can cause the motor to become too hot.
• Clean and lubricate the spindle shaft thread.
To do maintenance of the diamond drill
bit
• Make sure that the diamond tools segments are
sharp. Sharpen blunt diamond segments with a SiC
grind stone.
• Make sure that there is no vibration in the drill
bit. If there is vibration in the drill bit, the diamond
segments can come loose.
1473 - 002 - 08.03.2024
Not applicable for
PRCD on page 8 .
Make sure that no water
Do not use running water to
Before After
each use each use
*
*
X
* *
* *
X X
X
• Make sure that the diamond segments are
sufficiently larger than the inner and outer diameter
of the drill bit tube.
• Lubricate the drill bit thread with water resistant
grease. This makes it easy to loosen the tool.
• Make sure that the radial run out at the diamond
segments of the drill bit is not more than 1 mm.
After the
Daily each 300
first 100 h
*
X
O
After
h
X
17