Husqvarna DM 230 Manuel D'utilisation page 13

CAUTION:
dust extractor to collect the slurry.
1. Clean all grease and dirt from the top of the slurry
ring.
2. Attach 2-sided adhesive tape or apply spray glue
around the top opening of the slurry ring (A).
3. Put the sealing disc on the top opening as a cover
(B). Attach it tightly.
4. Look for the dimension of the core drill on the top of
the drill.
1473 - 002 - 08.03.2024
Use a slurry collector or wet
A
B
5. Cut a hole in the sealing disc in the nearest smaller
dimension as the core drill (0-150 mm).
6. Connect the slurry collector/wet dust extractor to the
connection of the slurry ring.
7. Put the slurry ring on the drill spindle (C).
C
8. Install the drill bit to the drill spindle (D).
9. Start the slurry collector/wet dust extractor.
D
13