Husqvarna DM 230 Manuel D'utilisation page 10

2. Push the power switch to start the product.
3. Release the power switch to stop the product.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do the daily maintenance. Refer to
schedule on page 16 .
3. Make sure that the nominal voltage and current in
the power outlet is the same as the voltage and
current of the product.
4. Make sure that the PRCD is started. Refer to
on page 8 and To examine the PRCD on page 9 .
5. Make sure that the work area is clean and bright.
6. Use personal protective equipment. Refer to
Personal protective equipment on page 8 .
7. Make sure that the product is installed correctly. The
drill bit must be attached correctly.
8. If you use the product with a drill stand, read the
operator's manual for the drill stand carefully and
make sure that you understand the instructions.
Make sure that the product is attached correctly.
10
Safety instructions for maintenance
•
•
•
Operation
9. If you do not use a drill stand, the auxiliary handle
Maintenance
10. When you operate the product dry, use a dust
11. When you operate the product wet, make sure that
PRCD
12. When you do inverted drilling, make sure that you
To use the product with a drill stand
WARNING:
maintenance should be carried out with
the motor switched off and the plug
disconnected.
Maintain power tools and accessories. Check for
misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the
power tool's operation. If damaged, have the power
tool repaired before use. Many accidents are caused
by poorly maintained power tools.
Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is
maintained.
must be connected and fully tightened. Refer to
set the auxiliary handle in an applicable position on
page 12 .
To prepare the product for dry
extractor. Refer to
drilling on page 12 .
the water system is not damaged and use the water
To prepare the product for wet
connector. Refer to
drilling on page 12 .
comply to the applicable instructions. Refer to
prepare the product for inverted drilling on page 12 .
CAUTION:
this section carefully.
Inspection and/or
To
To
If you use a drill stand, read
1473 - 002 - 08.03.2024