SOMFY ELIXO 500 230 V RTS Manuel D'installation page 11

Elixo 500 230V RTS / Elixo 800 230V RTS
Any failure to comply with the instructions given in this guide shall
exclude Somfy from all liability and invalidate the Somfy warranty.
If in any doubt when installing the drive, or to obtain additional
information, consult the website www.somfy.com.
The instructions may be modified if and when there is a change to the
standards or to the drive.
1.3 Preliminary checks
> Installation environment
ATTENTION
Do not spray water onto the drive.
Do not install the drive in an explosive environment.
Check that the temperature range marked on the drive is suited to the
installation location.
> Specifications of the gate to be motorised
A er installation, ensure that sections of the gate do not encroach onto
the pavement or public thoroughfare.
1.4 Electrical installation
The installation of the power supply must comply with the standards
in force in the country in which the drive is installed, and must be
carried out by qualified personnel.
The electric line must be exclusively reserved for the drive and equipped
with protection, comprising:
- a 10 A fuse or breaker,
- a differential type device (30 mA).
An all-pole power supply cut-off device must be provided. The
switches provided to ensure a cut-out of all poles on fixed appliances
must be connected to the power supply terminals and there must
a separation between the contacts on all poles to ensure complete
disconnection in conditions where category III high impulse voltage
is present.
It is recommended that you fit a lightning conductor (mandatory
maximum residual voltage 2 kV).
> Cable feed
Underground cables must be equipped with a protective sheath with
a sufficient diameter to contain the motor cable and the accessories
cables.
Low-voltage cables subject to inclement weather must be at least of
type H07RN-F.
For overground cables, use a cable grommet that will withstand the
weight of vehicles (ref. 2400484).
1.5 Safety instructions relating to installation
Do not connect the drive to a power supply (mains, battery or solar)
until installation is complete.
Ensure that any danger zones (crushing, cutting, trapping) between
the driven part and the surrounding fixed elements caused by the
opening movement of the driven part are avoided or indicated on the
installation (see the section entitled "Risk prevention").
Copyright© 2017 SOMFY ACTIVITES SA. All rights reserved.
DANGER
DANGER
WARNING
Modifying one of the elements provided in this kit or using an additional
element not recommended in this manual is strictly prohibited.
Monitor the gate as it moves and keep people away from it until
installation is complete.
Do not use adhesive to secure the drive.
Take care when using the manual unlocking device. Manual unlocking
may result in uncontrolled movement of the gate.
ATTENTION
Install any fixed control device at a height of at least 1.5 m and within
sight of the gate, but away from moving parts.
A er installation, ensure that:
- the mechanism is correctly adjusted
- the manual unlocking device is operating correctly
- the motorisation changes direction when the gate encounters an
object measuring 50 mm positioned halfway up the leaf.
It is mandatory to install an active safety edge with autotest function
in order for the installation to be compliant.
> Safety devices
For operation in automatic mode or remote operation, photoelectric
cells with autotest function must be installed.
In automatic mode, the drive operates in at least one direction with no
intentional activation by the user.
For operation in automatic mode, or if the gate faces a public road,
installation of an orange light may be required in accordance with the
regulations in the country in which the motorisation is installed.
> Clothing precautions
Take off any jewellery (bracelet, chain, etc.) during installation.
For manoeuvring, drilling and welding operations, wear appropriate
protection (special glasses, gloves, ear protection, etc.).
1.6 Regulations
Somfy declares that the product described in these instructions, when
used in accordance with these instructions, complies with the essential
requirements of the applicable European Directives and, in particular,
with the Machinery Directive 2006/42/EC and the Radio Equipment
Directive 2014/53/EU.
The full text of the EC declaration of conformity is available on the
following website: www.somfy.com/ce. Antoine CREZE, Head of
Regulations, Cluses
1.7 Assistance
You may encounter difficulties or have questions when installing your
drive.
Do not hesitate to contact us; our specialists are on hand to answer all
your questions.
Internet: www.somfy.com
WARNING
WARNING
DANGER
WARNING
EN
2