Publicité
Lay the connection cable securely (e.g. conduit pipe)
from the system tank to the control unit. Ensure that there
is adequate cable length for the maintenance of the elec-
trical components.
Fit the battery connector onto the battery.
Route the battery cable such that the LEDs are not cov-
ered or trapped.
Fasten the strain relief for all connection cables, tighten-
ing torque 0.5 Nm.
Fit the housing cover and fasten in place - screw tighten-
ing torque 1.2 Nm.
Installation and operating instructions
35 / 144
Publicité
