Publicité
Lay the connection cable securely (e.g. conduit pipe) from the system tank to the control unit. Ensure that there is ade-
quate cable length for the maintenance of the electrical components.
Attach ferrules (length 8 mm) to the cable ends.
Unscrew and remove the housing cover.
Mono/Duo: 4 screws in each corner of the housing cover
Route the connection cable through the appropriate cable
gland. If necessary, open predetermined breaking points
at the required predefined cable glands.
NOTICE
Observe IP54
Break out the cable glands with a suitable tool.
Press the rubber cable glands into the openings.
Cut the nipples off the inserted cable glands.
Fasten the connection cable to the terminal strips in
accordance with the wiring diagram.
To do so, use a suitable screwdriver to hold down the
respective cable clamp against the spring pressure until
the cable end has been inserted.
34 / 144
Installation and operating instructions
Publicité
