Publicité
1.
Using the template, mark the location
of the mounting points.
2.
R un th e e l ec tr ic al a n d w at e r
installations to the marked areas.
3.
Remove the cover of the heater
and assess the technical condition,
ensure the device has not been
damaged during transport, check the
connection of the safety switch.
4.
By default, the heater is prepared for
the power supply connection at the
top [14]. To change the connection
point, you must mount the connection
strip in the lower position [8]. Before
starting the assembly, the relevant
hole [7] or [12] must be broken out,
and a flexible cable protection [14]
should be installed in it.
3 3
44
4 4
1 1
2 2
9 9
8 8
6 6
7 7
8 8
6 6
7 7
5 5
6 6
7 7
5 5
12
Publicité
