Loading The Film; Taking Pictures; Programmed Auto (Full Auto) - Olympus IS-50 Mode D'emploi

8

LOADING THE FILM

1
Shutter curtain
Slide the back cover release
upward to open the back cover.
3
Place the film between the positioning guides
(A), aligning the film leader in the direction of
the arrow.
4 5
Close the back cover. The Make sure the exposure
film automatically advances counter on the LCD panel
to the first frame. Set the reads "
power switch to ON.
If "
2
1
2
Insert the film cartridge.
Be careful not to touch the
shutter curtain.
Correct
Incorrect
".
" blinks, reload the film.

TAKING PICTURES

— Programmed Auto (FULL AUTO)

1
Set the power switch to ON. The
lens will extrude and the LCD panel
will turn on.
Compose your shot. Press the "T"
side of the zoom button for
telephoto (120 mm) or the "W" side
for wide angle (28 mm).
After about 30 seconds of inactivity, the LCD panel goes out.
Do not look at the sun or other strong light sources
through the viewfinder.
2
Autofocus frame
Position the autofocus frame
on your subject.
If the autofocus indicator
blinks, the shutter cannot be
released.
The distance to your subject
is 0.6 (2.0 ft) m to infinity at
the wide-angle side and 0.9
(3.0 ft) m to infinity at the
telephoto side.
3
Press the shutter release button
halfway to focus on the subject.
After making sure that the
camera beeps and the autofocus
indicator lights in the
viewfinder, press the shutter
release button all the way to
take the picture. After the
shutter is released, the film
automatically advances to the
next frame.
9