Publicité
EN-34
5.2.2.5. Edit an Existed Method
1. Rotate the Rotation knob. The Method ID
2. Navigate to the method to be edited, then short press the Rotation knob.
3. Navigate to Edit method, then short press the Rotation knob to enter method editing.
4. Configure Drying Program, Drying Temperature, and Switch-off criterion in
sequence. If there's no change to a parameter, short press the Rotation knob to move
on.
Note:
For guidance on selecting a Drying Program and Switch-off criterion, please
refer to:
◦
Drying program (on page 27)
◦
Switch-off criterion (SOC) (on page 29)
5.2.2.6. Delete a Method
Attention:
When a Method is deleted, the corresponding Results will also be deleted.
1. Rotate the Rotation knob. The Method ID
2. Navigate to the method to be deleted, then short press the Rotation knob.
3. Navigate to Delete method, then short press the Rotation knob to delete the method.
The screen will display a confirmation note, e.g. "Method
MB62 Instruction Manual
will start to blink.
will start to blink.
01
Deleted.
Publicité
