Publicité
EN-32
5.2.2.2. Load a Method
1. Rotate the Rotation knob. The Method ID
2. Navigate to the desired method > short press Rotation knob > short press the knob
again to confirm selection. The selected method will be used in the measurements.
After a method is confirmed, the screen will back to the Home screen. The Method
ID
will display the ID you have just confirmed.
5.2.2.3. View the Parameters of a Step Method
A Step method contains multiple sets of parameters. Follow the following instructions to
view the parameters of a Step method.
Prerequisites:
• The Step method is selected.
Note:
For how to select a method, please refer to
To view the parameters:
From the Home screen, long press the Print button
Rotate the knob to navigate through the step parameters. Press
screen.
MB62 Instruction Manual
will start to blink.
Load a Method (on page
32).
to return the main
Publicité
