Gima NE-M01 Manuel De L'utilisateur page 21

21
Chapter 6
TROUBLESHOOTING
Problems
The device can't startup.
No atomizing or little
atomizing appears when
device working.
There is water around the
nozzle of nebulizer.
After startup, power
indicator lights about
1s, then immediately
goes out.
After turning on the
device, the power
indicator lights once, then
it is out immediately or
the device can not work
normally.
Nebulizer doesn't
automatically shutdown
when medication is
used up.
If the device still can't work normally after doing all methods above, pleas contact our after-sales service.
Chapter 7
MEANING OF SYMBOLS
Keep in a cool,
dry place
Keep away from
sunlight
Fragile, handle
with care
Reason analysis
Battery is not well installed.
Medication cup is not well installed.
No medication in medication cup
Improper medication
The nebulizing sheet is dirty
Due to temperature differences,
the temperature of medication cup
surface is relative low, medication
mist in contact with the nozzle, then
condenses into water droplets.
Medication cup is not well installed.
Medication cup is not loaded with
any medication
The battery had run down.
Medication may generate bubbles in
medication cup
Medication may attached on the
nebulizing sheet
The electrodes contacting with the
medication cup may be dirty
Stand-by
Temperature limit
Date of manufacture
ENGLISH
Solutions
Check the installation of battery, and reinstall
the batteries.
Check the installation of medication cup, and
reinstall it.
Trickle medication into medication cup,
remember do not exceed its maximum
capacity.
Consult a doctor if the medication is suitable
for the device.
Clean medication cup.
Remove medication cup, pour the water out.
Install medication cup once again.
Put the medication into medication cup after
consulting your doctor.
Replace the batteries immediately.
Press "ON/OFF" button to turn off the device,
and clear up the bubbles.
Press "ON/OFF" button to turn off the device,
and clean medication cup.
Press "ON/OFF" button to turn off the device,
and clean the electrodes.
Product code
Lot number
Serial number