Publicité
Setting up
• Your machine is ready to use when removed from the
box. Retain the packaging in case you need to return the
machine for repair.
• The punching mechanism is coated with a protective
film of lubricant, which will mark your paper. Clear this
by punching scrap sheets of paper until clean prior to
binding.
Comb binding instructions
Each step relates to the illustrations at the front of this
manual.
1. Set the paper size
Ensure the punch handle is in the upright position
1
before centering the paper.
Load the first paper stack into the comb punch slot (4).
2
Adjusting your machine for A5:
Adjust the machine by sliding the paper edge guide (5)
3
located next to the punch slot from A4 to A5 (fig. C).
2. Punch paper
Lower the raised handle until the paper is punched, and
support the machine when lifting the handle to the upright
position (fig. D).
3. Comb binding
Place the plastic comb open side up on the comb
1
opening teeth (3) (fig. E).
Turn the Comb selector (fig. B) to COMB on the dial.
2
To open the comb, turn the comb opening handle (2).
3
Load each paper stack onto the opened comb until the
4
entire document is loaded.
To close the comb, rewind the comb opening handle
5
and lift the bound document from the metal teeth.
Binding tips:
• Load the rear cover onto the open comb first, followed by
the internal sheets and front cover.
• To edit your document, additional sheets may be included
or removed by placing your document (comb open side
up) onto the metal teeth and following step 5 instructions
again.
• For further hints and tips please visit our website:
www.gbceurope.com
Instruction Manual
Wire binding instructions
For use with GBC 34 loop wire elements.
1. Set the wire
Lift the punch handle (1) to the upright position.
1
Place entire document so it rests on the paper support
2
(fig. A).
Turn the Wire selector (fig. B) until the number matches
3
your wire size.
2. Set the paper size
Ensure the punch handle is in the upright position
1
before centering the paper.
Load the first paper stack into the wire punch slot (4).
2
Adjusting your machine for A5:
Adjust the machine by sliding the paper edge guide (5)
3
located next to the punch slot from A4 to A5 (fig. C).
3. Punch paper
Lower the raised handle until the paper is punched, and
support the machine when lifting the handle to the upright
position (fig. D).
4. Wire binding
Place the wire (open side up) on the wire support (fig.
1
F).
Feed each paper stack onto the wire and repeat until
2
your document is complete.
Support the document and wire on removal from the
3
wire support.
Insert the document into the wire closing jaws (wire
4
opening face down) (fig. G).
Support the document and pull down the wire closing
5
handle (2) to close the jaws.
Use the wire closing guide (located in the wire closing
6
jaws) to ensure correct closure of the wire.
Binding tips:
To hide the spine of the wire:
• Load the internal sheets onto the wire first, repeating until
all are loaded.
• Load the front PVC cover onto the wire element.
• Load the rear cover onto the wire element last.
• It is best to close the wire a little, check, and then close
the wire a little more until you are happy with the wire
closure.
• Always use the wire size closing guide (located in the
wire closing jaws) to prevent over closing the wire.
• For further hints and tips please visit our website:
www.gbceurope.com
EN
5
Publicité
