Publicité
Before Use
EN
1. Place the Base Station and Connect to an Electrical Outlet
Place the base station in a location that is as open as possible with a good
Wi-Fi signal. Remove any objects that are closer than 1.5 m from the front and
5 cm from either side of the base station. Insert the power cord into the base
station and plug it into the socket.
Note:
· Make sure that no objects might block the signaling area.
· To prevent water stains from wetting wood floors or carpets, placing the
base station on tile floors or marble floors is recommended.
10
＞5 cm
＞5 cm
＞1.5 m
I : ON
O : OFF
Firmly insert the power cord
upwards until the indicator turns
on.
2. Install the Ramp Extension Plate
3. Remove Robot Protections, and Install the Side Brush and Mop
Assembly
②
Side Brush Clip
①
③
Publicité
