Mounting Of Soffit Elements Pp 45 Le, Pp 45 Lev And Pp 45 Lew90 - Maico PP 45 RHK Notice De Montage

UK | 10 Mounting of soffit elements PP 45 LE, PP 45 LEV and PP 45 LEW90
10 Mounting of soffit elements
PP 45 LE, PP 45 LEV and
PP 45 LEW90
PP 45 LE/LEV/LEW90 not suited for
i
PPB 30 units – use PP 45 LE/LEV/
LEW90 only in combination with
PP 45 units.
Incline of at least 1...2%
L Window soffit
P Plaster edge max. 7 mm
36
NOTICE
Installation position, internal wall: Once
the plaster has been applied or wallpaper put
up etc., the wall sleeve must end flush with
the internal wall.
Installation position of window soffit:
The condensate drip edge must protrude
20 to 25 mm beyond the external plastering
once this plastering is applied.
1 Wall sleeve Ø 160, not in scope of supply
2 Rubber seal wall sleeve
3 Soffit element PP 45 LE
4 Stainless steel holder for drip edge and
integrated wall seal [4.1]
4.2 Screws (4 pieces)
5 Soffit external grille
5.1 Screws (2 pieces)
Mounting preparations PP 45 LE
● Determine installation position. Ensure
mounting is on a level wall surface. Note
dimensions. Take account of a 7 mm plaster
edge [P] all the way round.
● Adjust external wall façade insulation to the
soffit element.
! WARNING
Risk of injury if the soffit element or wall
sleeve comes loose. Only mount on walls
with sufficient load-bearing capacity. Firmly
plaster in soffit element and wall sleeve.