Maico PP 45 RHK Notice De Montage page 34

UK | 9 Mounting the wall sleeve and external cover
Mounting PPB 30 AK and PP 30 AE/AW/AS
– once external wall is fully plastered –
Position of external
cover and wall sleeve
Use drilling template!
1. Remove plaster protective cover, place
drilling template over the wall sleeve, align
it and mark the fixing holes. Observe the
"TOP" position.
2. Drill the holes and insert dowels.
3. Remove front cover from housing.
PPB 30 AK: Push onto the two locking
levers below. PPB 30 AE/AW/AS: Remove
the screws on both sides. Then, remove
the front cover upwards.
34
4. On the side of the housing facing the wall,
attach a silicon ring [S] around the entire
hole to seal it off from the wall.
5. Screw housing [G] to external wall with 4
screws. Suitable mounting material is to
be supplied by the customer.
NOTICE
Lack of air if housing [G] is not fitted
tightly on the external wall. When fitting
the housing, ensure that the back side of the
silicon ring [S] is flush and lies close to the
external wall.