Publicité
9.4 Ordinary cleaning
9.4.1 Cleaning the inside of the firebox
Daily or before each ignition, it is necessary to
check that the burn pot is clean to ensure the
free flow of combustion air from the holes of the
burn pot itself.
Vacuum the ash accumulated in the burn pot
(Fig. 51).
ATTENTION: Remove the ash from the
combustion chamber because the salts
present cause corrosion of the metal. In
addition, the ash could block the pas-
sage of air, varying the development of
the flame which, if it approaches the
glass, would increase corrosion.
Remove the ash collected in the ash compart-
ment in Fig. 52.
Using an ash vacuum can simplify the
cleaning operations
80
9.4.2 Cleaning the glass
It is carried out with a damp cloth or with damp-
ened paper that is wiped over the ash.
Rub until the glass is clean.
Do not clean the glass while the appliance is
operating and do not use abrasive sponges.
ATTENTION: Do not use solvents, acids,
soaps, liquid detergents or aggressive
products.
Fig. 51
Fig. 52
Fig. 53
004779216 - 18/09/2024
Publicité
