Operating The Downdraft - ETNA AKI480ZT Mode D'emploi

OPERATION

Operating the downdraft

1 2 3 4
16 15 14
Depending on the installation, this appliance allows you to choose the operating mode
(extraction or recirculation),
Upon first start-up using key (15), the display shows which operating mode is enabled.
• Recirculation: the display shows the letter C and the filter reset key (14) flashes quickly.
• Extraction: the display indicates the letter C and the filter reset keys are off.
During this phase you can change the operating modes by touching key (14).
A beep confirms the program change.
Once the set time elapses, the program will exit this operating mode and goes to standby mode
or by pressing the on/off button of the motor.
To access the operating mode selection again, turn off power to the appliance and then power
it again.
NOTE: in extraction mode, when the device is turned off, it remains operating for 20 minutes at
a minimum speed, to allow evaporating any possible condensation that has formed during the
cooking phases.
Motor on/off key (15):
When touched, this key starts the motor if touched again, it stops the motor.
By operating the keys "+" and "-" the user can modify the suction speed (power). For the version
with 4-speed (serial) motor, only the 4th speed is timed.
Suction speed (power) decrease key (2):
When touched, the key "-" decreases the suction speed of the downdraft.
Suction speed (power) increase key (3):
When touched, the key "+" increases the suction speed of the downdraft.
EN 18