ETNA AKI480ZT Mode D'emploi page 101

TROUBLESHOOTING
Symptom
Flash symbol in the display.
Error code U400 and/or
continuous beep.
Code G on downdraft display
(alternately with the selected
power.)
Code S on downdraft display
(alternately with the selected
power.)
Flashing 8 on downdraft
display.
Other error codes.
Possible cause
You have pressed two or more
keys at the same time.
The control panel is dirty or
has water lying on it.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
Grease filter 30
operating hours.
Odor filter 120
operating hours.
Excess liquids inside the
downdraft interior.
Defective generator.
Solution
Do not operate more than one
key at the same time.
Clean the control panel.
Let your connection be
changed.
Clean the grease filter.
Use the downdraft clean
function.
Replace the Odor filter.
Use the downdraft clean
function.
Dry and clean the downdraft
interior (see: Presence of
liquids inside the device).
Contact the service
department.
EN 23