ETNA AKI480ZT Mode D'emploi page 102

TROUBLESHOOTING
Table of appliance errors.
These errors appear on the cooking top display.
Error code
C, E, C flashing, E
flashing or
- symbol
E2
E3
E4, E5, E6, E7, E8, E9,
EA, EC, EH,
No display / Function
u
Er31, Er47, Er22, Er20
or segments on the
display lighting up
cyclically
EN 24
Description
If the display in
one of the cooking
zones shows one
of these symbols,
an intervention
has occurred or
is occurring in the
system's basic
configurations.
Excessive
temperature on the
cooking zone.
Malfunction due to the
use of inappropriate
cookware materials.
magnetic properties at
Hardware fault
Voltage or touch
control error.
Pot not detected
Touch control fault
Possible causes
Problems or changes
detected to the
system's basic centre, specifying the
configurations.
Overheated pot.
decreasing the power
or removing the pot.*
Pots of
inappropriate
Use pots of a suitable
material or
possible loss of
higher temperature.
Hardware errors
detected centre, specifying the
Faulty electrical
connection or faulty
centre, specifying the
component.
Inappropriate Refer to the section of
cooking pot the manual on suitable
Touch control error
detected centre, specifying the
Solution
Contact the
authorised service
error code.
Allow the system
to cool down,
material or replace
them.*
Contact the
authorised service
error code.
Contact the
authorised service
error code.
Use a suitable pot.
recipients.*
Contact the
authorised service
error code.