Replacing the Disposable
C14
Dust Bag
* Replace the disposable dust bag when it is full.
C14-1—
Lift the dustbin and remove the
bag vertically as shown.
Note: Pulling the dust bag handle to remove the bag will seal
the bag to prevent leakage.
C14-2—
Discard the dust bag and clean
around the filter with a dry cloth.
C14-3—
Slot in a new disposable dust bag
as shown. Slide until it reaches the
bottom of the slot and reinstall the
dustbin securely.
Note: Always install a dust bag before putting back the
dustbin top lid to avoid auto-emptying without the bag. You
can also disable auto-emptying in the app.
Cleaning the Air Duct
C15
* Clean as required.
Follow the following steps to clean the air
duct and avoid blockages.
C15-1—
Remove the clean water tank, dirty
water tank, and dustbin.
C15-2—
Remove the water filter and wipe
off any water marks with a cloth.
C15-3—
Grasp the sides of the dock base
upward to disassemble and turn it
over to check any blockage.
C15-4—
Clean the air inlet with a cotton
swab if it gets blocked and wipe it
with a dry cloth.
C15-5—
Carefully place the dock upside
down on a hard floor covered with
a soft towel.
C15-6—
Unscrew the three screws and
remove the cover.
C15-7—
Wipe the air duct and duct cover
with a dry cloth.
C15-8—
Reinstall the cover and screw it
back in place.
14
Basic Parameters
Robot
Model
S81USP
14.4V/5200mAh
Battery
lithium-ion battery
Rated Input
20V
Charging Time
Approx. 4 hours
Note: The serial number is on a sticker on the underside of
the robot.
Empty Wash Fill Dock
Name
Empty Wash Fill Dock
EWFD07LRR,
Model
EWFD08LRR
Rated Input Voltage
120V~
Rated Frequency
60Hz
Rated Input
9.5A
(Dust Collection)
Rated Input
1.2A
(Non-Dust Collection)
Rated Output
20V
14.4V/5200mAh
Charging Battery
lithium-ion battery
1.5A
1.5A