Publicité
During installation, maintenance and use of the appliance, carefully follow the instruc-
tions provided in the manual. Carefully read the instruction manual in all its parts before
carrying out any operation on the pump.
In the case of appliances without a plug, a means of disconnecting the power supply,
with omnipolar contact separation that fully disconnects under overvoltage category III,
must be installed in the power supply system according to the current installation rules.
This equipment is not intended to be used by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been supervised or instructed on the use of the appliance by a person who is
responsible for their safety.
This appliance can be used by children over the age of 8 and by people with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have
been supervised or instructed on the safe use of the appliance and understand the hazards
involved. Children must not play with the appliance. Cleaning and user maintenance
should not be performed by children without supervision.
Do not use the electric pump in swimming pools, basins, ponds and in similar places
when people are in the water.
The appliance must be powered by means of a residual current device, with residual
operating current not greater than 30 mA.
Three-phase appliances must be protected against short-circuits and overloads by a class
10 protection device, in accordance with IEC 60947-4. Set the rated current according to
the value shown on the rating plate.
Before starting any work on the electric pump, make sure it has been disconnected from
the power supply and cannot be accidentally reconnected.
If the power cable is damaged, it must be replaced by the Manufacturer, their service
centre or qualified personnel.
The maximum head of the pump is indicated in metres, on the rating plate applied on the pump.
The pump can work continuously at the maximum temperature indicated on the rating plate (+40°C).
The pump is not protected against freezing. According to the instructions in the manual, it must be removed
and emptied of water when there is a risk of freezing.
Refer to the "INSTALLATION" chapter to install the equipment.
12
Publicité
