Wheel Adjustment; Adjusting Handle Height - Kunzle & Tasin Bona Scorpion Manuel D'utilisation

Machine Adjustment Procedures (Cont.)

Wheel adjustment

To adjust wheel position, proceed as follows:
1) Loosen the locking nut.
3) Once the desired position has been
reached, secure the locking nut.

Adjusting handle height

To adjust handle height, proceed as follows:
1) Ensure the power supply cable is
disconnected from the mains and the
machine.
3) Loosen the screws (A) until the handle
unit is mobile.
2) Turn the screws clockwise to raise the end of the side drum cover off
the floor. Turn the screws counter-clockwise to lower the end of the
side drum cover towards the floor.
2) After releasing the knob (A) and moving the lever
forwards (B), lift the tube (C) and release the bar
(D) from the cylinder (E).
4) Raise or lower the handle unit (A) until reaching
the upper or lower stop.
Bona Scorpion Manual
17
EN