Publicité
Check the overall condition of the appliance;
Check that the appliance does not make abnormal noises;
Clean the condenser and its filter (see Section 6.2 "Cleaning the appliance").
If damage or malfunctions are found during these checks, do not use the appliance and contact
your dealer or a qualified and authorized technician.
WARNING! Servicing must only be performed by personnel who are authorized by
the dealer or the manufacturer, using original accessories and replacement parts.
It is severely forbidden to try to repair the appliance yourself. Such action will void
the warranty and put you at risk of injury.
6.4 If the appliance is not used for a long period of time:
Disconnect the plug from the electric socket;
Remove all food and drink from the appliance and transfer into another refrigerator or freezer;
Carefully clean and dry the appliance;
Cover the appliance with a fabric sheet which allows air to circulate but also protects it from
dust and dirt.
7. Troubleshooting
PROBLEM
Direct sunlight or near heat sources.
Insufficient
cooling power
Control unit is performing a defrost cycle.
The door is not completely closed or has
The door seal is damaged or deformed.
The evaporator is covered in ice.
Dirty condenser filter.
The electric plug is not inserted in the
Not cooling
The compressor does not turn on.
Power failure
The appliance is not positioned on a flat sur-
Very noisy
There is a vibration caused by loose screws
Too many products inside the appliance.
The compressor
The door is not closed or has been opened
does not shut
off automati-
cally
The above cases are presented merely as examples of possible problems. In the event of any prob-
lem, immediately switch the appliance OFF and contact the dealer.
TRANSLATION OF THE ITALIAN ORIGINAL INSTRUCTIONS
CAUSES
been opened too long.
socket.
face or the legs are not properly adjusted.
or bolts.
too long.
SOLUTION
Move the appliance away from the heat
sources.
Wait for the control unit to complete the de-
frost cycle (max. 20 minutes).
Close the door completely, keep the door
open for shorter periods of time.
Contact the dealer.
Check that the door and the gasket seal well
and that no hot food has been put inside the
appliance. Contact the dealer.
Clean the condenser filter (see Section 6 -
Cleaning and servicing).
Insert the electric plug in the socket.
Contact the dealer.
Check the power supply.
Place the appliance on a flat surface and ad-
just the legs so that the appliance rests sol-
idly on the ground.
Check that the screws and bolts have not be-
come loose during operation or transport.
Remove excess products.
Only open the door as long as necessary and
check that it is properly closed.
- 29 -
Publicité
