Télécharger Imprimer la page

Amitek AKT690TN Manuel D'installation, Utilisation Et Entretien page 25

Publicité

The power supply cable must not be laid on carpets, tablecloths, mats or on other heat insu-
lating materials, nor covered or immersed in water or other liquids and it must be positioned
where it cannot be walked on;
Position the appliance so that the plug is always accessible;
Do not use extension cords, adapters or reducers;
Take care that the power supply cable does not cause tripping hazards.
5.2 Handling and positioning
Ensure that, from the point of view of the overall dimensions (see Table 1 - Section 9), the space
provided for the appliance allows its correct use and easy servicing as indicated in subsection 6.
ATTENTION!
Remove the appliance from the packaging, be sure to follow the instructions in Section 4 (En-
vironmental notes) with regard to the storage and disposal of the packaging materials;
While always keeping the appliance level, move and position it on a stable and correctly lev-
elled surface (the height of the legs can be adjusted to compensate for any uneven surfaces).
In order to avoid damage to the compressor and cooling system, never tilt the
appliance more than 45° during transport and positioning.
After transport or handling, wait at least 4 hours after the appliance has been
positioned before switching it on. This will allow the compressor oil to level and
prevent it from entering the cooling circuit, causing irreversible damage to the
compressor and the evaporator.
Never place the appliance on a flammable surface (e.g. carpet, rugs, tablecloths, etc.);
Do not position the appliance near open flames, electric cookers, ovens or other sources of
heat, such as, for example, places exposed to direct sunlight. Heat can damage the surface of
the appliance and adversely affect its operation;
Position the appliance so that the sides and rear are always at least 5 cm from walls, furniture
and other objects, and the top has at least 30 cm of clearance. This is to ensure good air cir-
culation and easier access to all parts of the appliance as well as to provide the necessary space
for its operation;
The appliance must not be built into furniture or masonry walls;
Do no drill holes into the appliance or attach objects to it;
The appliance must not be used if it is out of order, damaged or has suffered impacts;
To avoid hazardous situations for the user do not use accessories or spare parts, which differ
from those recommended by the manufacturer. The appliance could be damaged or prove to
be a risk for the health and life of individuals.
5.3 Use
Clean the appliance before its first use (see Section 6 - Cleaning and servicing);
Insert the plug into an individually interlocked protected electric socket in compliance with the
regulations;
Only put food products inside the appliance after it has reached the operating temperature set
on the control unit (see Section 5.4 - Operation);
TRANSLATION OF THE ITALIAN ORIGINAL INSTRUCTIONS
- 25 -

Publicité

loading