Publicité
In the cases below, wait 20 minutes prior to taking a temperature.
Factor
Extreme hot and cold room temperature
Hearing aid
Lying on pillow
Use the untreated ear if ear drops or other ear medications have been placed in the ear canal.
Memory mode
This model stores the last 9 temperature measurements.
1
To display the stored measurement, the thermometer must
be turned on.
2
Press the Mem button.
The display shows the temperature, and when releasing the
Mem button, the stored temperature for that memory number
is displayed, together with "M".
3
Each time the Mem button is pushed, the stored
reading and an M is displayed to indicate each
temperature measurement (eg. M2).
Memory mode is automatically exited by
not pressing the memory button for 5 seconds.
1
The last temperature taken is stored in its memory
and will be automatically displayed for 5 seconds
when it is turned on again.
Night light feature
The thermometer includes a convenient night light to illuminate
the display in a dim environment.
The light will turn on when you press any button. It will stay on until the
thermometer is inactive for up to 15 seconds even after temperature is
taken.
Changing the temperature scale
Your Braun ThermoScan is shipped with the Celsius (°C) temperature scale activated. If you wish to switch to
Fahrenheit (°F) and/or back from Fahrenheit to Celsius, proceed as follows:
1
Make sure the thermometer is turned off.
Press and hold down the Power button
2
the display will show this sequence: °C / SET / °F / SET.
8
Affects
. After about 3 seconds
3
Release the Power
button when the desired temperature scale is shown.
There will be a short beep to confirm the new setting, then the thermometer is turned off
automatically.
Care and cleaning
The probe tip is the most delicate part of the thermometer.
It must be clean and intact to ensure accurate readings.
If the thermometer is ever accidentally used without a lens filter, clean the
probe tip as follows:
Very gently wipe the surface with a cotton swab or soft cloth moistened
with alcohol. After the alcohol has completely dried out, you can put a new
lens filter on and take a temperature measurement.
If the probe tip is damaged, please contact Consumer Relations.
Use a soft, dry cloth to clean the thermometer display and exterior. Do not use abrasive cleaners.
Never submerge this thermometer in water or any other liquid. Store thermometer and lens filters
in a dry location free from dust and contamination and away from direct sunlight.
Additional lens filters (LF 40) are available at most stores carrying Braun ThermoScan.
Replacing the batteries
The thermometer is supplied with two 1.5 V type AA (LR 06) batteries. For
best performance, we recommend Duracell
®
1
Insert new batteries when the battery symbol appears on the display.
Open the battery compartment. Remove the batteries and replace with
2
new batteries, making sure the poles are in the right direction.
3
Snap battery door into place.
Only discard empty batteries. To protect the environment, dispose of
empty batteries at your retail store or at appropriate collection sites
according to national or local regulations.
Calibration
This device was designed and manufactured for a long service life, however it is generally
recommended to have the device inspected once a year to ensure correct function and accuracy.
Please contact the authorized service centre located in your country.
Note: The calibration checking is not a free service. Please contact the Authorized Service Centre to
get a quotation before you send out the product.
Manufacturing date is given by the LOT number located in the battery compartment.
The first three (3) digits after LOT represent the Julian date that the product was manufactured and
the next two (2) digits represent the last two numbers of the calendar year the product was
manufactured. The last identifiers are the letters that represent the manufacturer.
An example: LOT 11614KTC, this product has been manufactured on the 116th day of the year 2014.
alkaline batteries.
9
Publicité
