Publicité
3-5. Installing Welding Power Source Onto Rack
2
Have only qualified persons make
this installation.
!
Turn Off welding power
sources before inspecting
or installing rack.
1
Welding Power Source
2
Front Mounting Bracket Pin
Position welding power source
onto rack shelf so pins of front
mounting bracket are fully engaged
to front of welding power source.
3
Rear Mounting Bracket
Position rear mounting bracket so
its pins are fully engaged to rear
panel of welding power source.
4
Securing Bolts And Nuts
For CST 250 / 280 Models
5
Rear Mounting Holes
Install supplied bolts through Rear
Mounting Bracket and Rear Mount-
ing Holes. Install bolts and tighten.
For Maxstar 200 Models
6
Forward Mounting Holes
Mounting is the same as for the
CST 250 models, except that the
Rear Mounting Bracket will align
with the Forward Mounting Holes.
4
3
6
1
5
803 168-A
OM-2238 Page 13
Publicité
