Publicité
1
Instructions for using a heat gun or torch:
•
Read important warnings on page 1 and follow safety
precautions provided with heat gun or torch.
•
When using a torch use a soft yellow, low-heat flame.
Apply just enough heat to do the job.
•
Keep torch or heat gun moving
continuously to distribute the heat
evenly to avoid overheating,
blistering or charring the
heating cable and heat-
shrinkable tubes.
•
Replace any heat-damaged
parts.
3
•
Shrink tubes into position until
adhesive flows out ends.
•
Allow assembly to cool before
installing the expansion loop.
North America
Tel +1.800.545.6258
Fax +1.800.527.5703
thermal.info@nVent.com
©2023 nVent. All nVent marks and logos are owned or licensed by nVent Services GmbH or its affiliates. All other trademarks are the property of their respective owners.
nVent reserves the right to change specifications without notice.
RAYCHEM-IM-H54744-EMKXEJ-EN-2310
2
•
Slide tubes over the heating cable as shown.
•
Place one heat-shrinkable tube over each end
of the expansion tube.
Heating cable
Heat-shrinkable tube
6 in (152 mm)
4
2 in
(51 mm)
2 in
(51 mm)
4 in
(102 mm)
2 in (51 mm)
Expansion tube
24 in (610 mm)
Concrete
expansion joint
Heating
cable
Reinforcing
bars
Expansion tube
Sand
nVent.com/RAYCHEM
Publicité
