Publicité
Liens rapides
Publicité
Manuels Connexes pour nVent RAYCHEM EMK-XEJ
Sommaire des Matières pour nVent RAYCHEM EMK-XEJ
- Page 1 EMK-XEJ Electromelt Expansion Joint Kit Installation Instructions...
- Page 2 DESCRIPTION The nVent RAYCHEM EMK-XEJ Expansion Joint Kit is for use with ElectroMelt EM2-XR heating cable and is used to form an expansion loop at expansion joints. Materials for one expansion joint are included. These installation instructions should be used in conjunction with the ElectroMelt System Design Guide (H53393) and ElectroMelt System Installation and Operation Manual (H58086).
- Page 3 WARNING: CAUTION: The heating cable is an electrical device • Damaged bus wires can overheat or Health Hazard: Overheating heat-shrinkable short. Do not break bus wire strands that must be installed correctly to ensure tubes will produce fumes that may cause when scoring the jacket or core.
- Page 4 Instructions for using a heat gun or torch: • Slide tubes over the heating cable as shown. • Place one heat-shrinkable tube over each end • Read important warnings on page 1 and follow safety of the expansion tube. precautions provided with heat gun or torch. •...