Publicité
Les langues disponibles
Les langues disponibles
16. Troubleshooting
Fault
The appliance
does not start.
Water was not
pumped out of
the dishwasher.
Fault
Foam in the
appliance
Blotched ap-
pliance acces-
sories
40 - English
Technical faults
Possible cause
Fuse defective or circuit
breaker tripped
Appliance door is not ful-
ly closed
Power supply interrupted
Drain hose is kinked
Filter (5) blocked
Drain blocked
General faults
Possible cause
Incorrect detergent
Detergent with colour ad-
ditives was used.
Solution
Change the fuse or switch on the
circuit breaker again. Make sure
that the electric circuit is protected
with at least 10 ampere.
Switch the appliance on.
Close the door correctly. It must
audibly click into position.
Connect the mains plug (21) to a
socket correctly.
Route the hose so that it is not
kinked.
Clean the filter (5) regularly.
Check the drain. Make sure the
drain hose is properly installed.
Solution
Only use detergent that is suitable
for household dishwashers.
If foam has formed, open the ap-
pliance and wait approx. 20–30
minutes until the foam has reced-
ed.
Fill the water tank with 1.5 l wa-
ter and allow the water to drain
manually.
If necessary, repeat the process
several times until the foam has
been rinsed away.
Only use detergent without colour
additives.
Publicité
