Publicité
Les langues disponibles
Les langues disponibles
10.4. Setting salt consumption
For good dishwashing results, the dishwasher needs low-lime water. Adding regeneration
salt helps to achieve the required water hardness with the aid of the softening system. To
maintain the function of the softening system, regeneration is performed regularly, resulting
in higher water and energy consumption during the process (see table below).
Set the required salt consumption, depending on the local water hardness.
The table below shows what setting is necessary for your local water hardness.
Ask your water utility about the water hardness.
Water hardness
mmol/l
dH
(degree
(milli-
of German
mole per
hardness)
litre)
0–5
0–0.94
6–1 1
1.0–2.0
12–17
2.1–3.0
18–22
3.1–4.0
23–34
4.1–6.0
35–55
6.1–9.8
* When regeneration is carried out during a program, an additional 2.2 l of water is required,
the energy consumption increases by 0.01 kWh and the program is extended by 4 minutes.
Close the appliance door.
Press the
button (19) to switch on the appliance and make settings.
Press and hold the P button (18) for approx. 5 seconds.
Then press the P button (18) several times in accordance with the table above to set the
salt consumption.
If you do no press any button within 5 seconds, the appliance switches to standby
mode.
Regeneration
at every X
program se-
quence*
H1
–
H2
10
H3
5
H4
3
H5
2
H6
1
Salt con-
sumption
P must be
pressed
Press 1 x
OFF
Press 2 x
OFF
Press 3 x
OFF
(Factory set-
tings)
Press 4 x
ON
Press 5 x
ON
Press 6 x
ON
Display
LED ON/LED OFF
ECO
OFF
ON
ON
OFF
ON
ON
OFF
OFF
OFF
ON
ON
OFF
English - 23
Publicité
