SilverCrest 378202 21 Mode D'emploi page 38

 Remove the lower and upper spray arms (3/4) inside the appliance (lower spray arm,
see Fig. U) to clean the spray arms (3/4). Carefully pull off the spray arms (3/4)
and remove them. Clean the spray arms (3/4) under running water and check that the
openings are not blocked. Refit the spray arms. After replacing the spray arms (3/4)
check that they rotate freely.
 In case of grease deposits, run the intensive program without a load to clean the inte-
rior.
 To remove stains or soiling from the interior surfaces, use water and a cloth dampened
with a little vinegar or detergent suitable for a dishwasher.
13. Antifreeze protection
When operating in cold environments, e.g. during winter months, pay attention to the fol-
lowing information after each wash cycle to prevent freezing:
 Pull the mains plug (21) out of the mains socket.
 Turn off the water supply, if necessary, and disconnect the water hose from the water
inlet valve (22).
 Empty the water tank as described under "12.1. Draining water manually" on page
35.
 Allow the water to drain out of the hose and valve (e.g. into a bucket).
 Reconnect the hose to the water inlet valve (22).
 Remove the filter system (5) on the base of the appliance and collect the remaining
water from the appliance base using a rag or sponge.
Contact customer services or a similarly qualified person if the appliance does
not function due to freezing.
38 - English
Fig. U