SilverCrest 378202 21 Mode D'emploi page 29

11.1. Potential operating lights
Extra dry active (see Fig. B, 16)
Warning light: too little special salt (see Fig. B, 17)
Quick program select-
ed (top LED lights up) (see
Fig. B, 20)
Intensive program selected
(middle LED lights up) (see
Fig. B, 20)
ECO Eco program selected
(bottom LED lights up) (see
Fig. B, 20)
Glass program selected
(both top LEDs light up)
(see Fig. B, 20)
Baby bottle program se-
lected (both bottom LEDs
light up) (see Fig. B, 20)
Potential error messages are indicated by flashing or illuminated operating
lights. For more information, see section "17. Error messages" on page 43.
11.2.
To start the appliance, proceed as follows:
 Add the detergent, rinse aid and, if necessary, salt depending on the desired program.
 Insert the dish rack (8) and cutlery tray (10) (see section "10.7. Arranging the dishes and
cutlery" on page 25) and push the dish rack into the dishwasher.
 Plug the mains plug (21) into the socket.
 Press the
button (19) to switch on the appliance.
 Turn on the water supply fully or fill the water tank manually.
 Press the program selection button P (18) several times to select the required program:
Quick, glass, baby bottle, intensive or ECO cleaning program.
 You can also choose to switch on an extra drying cycle for these programs (except the
Quick program active (top LED flashes)
(see Fig. B, 20)
Intensive program active (middle LED
flashes) (see Fig. B, 20)
Eco program active (bottom LED flashes)
(see Fig. B, 20)
Glass program active (both top LEDs
flash) (see Fig. B, 20)
Baby bottle program active (both bot-
tom LEDs flash) (see Fig. B, 20)
Switching on the appliance
English - 29