SilverCrest 378202 21 Mode D'emploi page 18

8. Spare parts
If you would like to order spare parts, please contact us using the contact form at
www.mlap.info/contact.
The minimum period for the supply of electronic components for your dishwasher is 7
years. For the supply of spare parts such as seals, spray arms, drain filters, internal shelves
and plastic peripherals such as baskets and lids, the minimum period for your dishwasher
is 10 years.
9. Installation
WARNING!
Risk of electric shock and material damage!
There is a risk of electric shock as well as material damage
if the appliance is connected improperly.
 The electricity and water supply should only be connect-
ed by a qualified expert.
9.1. Setup and levelling
 Install the appliance on a stable, flat surface close to a drain and water connection:
− on a table/work surface
− in a ventilated cupboard.
 Only connect the mains plug (21) to a properly installed and freely accessible socket if
the water supply and outlet have been connected correctly (see next section).
9.2. Connecting to a water supply
NOTICE!
Damage to the appliance!
If the appliance is connected improperly, there is a risk of
damage to the appliance.
 The hose must be free of kinks and connected carefully.
 Connect the water supply hose (22) to a cold water tap with a 3/4" thread (see Fig.
D). You can also connect the supply hose to a hot water tap if the water temperature
does not exceed 70 °C.
This reduces wash time by about 15 minutes.
 Screw the hose connection hand tight.
The water hose is designed for a water pressure of up to 10 bar. We recommend closing
the water supply off after use, especially if your house connection does not have a pres-
sure reducer.
18 - English