Publicité
Les langues disponibles
Les langues disponibles
Be sure that you or your installer follow these instructions closely so that the new dishwasher works properly and that
you're not at risk of injury when washing dishes.
CHECK THE PARTS AND TOOLS
STEP 1
Before starting on the installation, prepare all the necessary tools and parts required to install the
dishwasher. This will save installation time and simplify the installation process.
PARTS REQUIRED
Provided with the dishwasher. Check when you unbox the dishwasher in Step 5.
Installation brackets
X2
Kick panel
NOT PROVIDED
Twist-on wire
connectors
Hot water
supply line
For the hot water supply line, we strongly recommend
using copper tubing with a compression fitting or a
flexible stainless steel braided hot water supply line.
Installing the Dishwasher
ST3.5*9 X2
(for the installation
bracket)
Condensation strip
Strain relief
90° Elbow
Air gap
Rubber connector
ST3.9*13 X2
(for the kick plate)
Adjustment cap X2
Electrical tape &
standard duct tape
Tube Fittings
Hose clamp
WARNING
Do not use plastic tubing. Plastic
tubing can deteriorate over time and cause a leak
inside the tube fitting.
4
ST4*14 X2
(for installation
brackets)
Cable tie
(for the drain hose)
Power cable
Teflon tape or
sealing compound
Publicité
