Publicité
Les langues disponibles
Les langues disponibles
LEVELING THE
STEP 8
DISHWASHER
1. Open the door and place the level against the top of
the tub on the inside and check if the dishwasher is
level. If it is not level, rotate the leveling legs at the
bottom front of the dishwasher until the dishwasher
is level. See the first note below for instructions on
adjusting the height of the front legs.
2. Use the level to check if the dishwasher is level front
to back, as shown in the figure to the right. If the
dishwasher is not level front to back, adjust the height
of the rear leg until the dishwasher is level. See the
second note below for instructions on adjusting the
rear leg.
3. Open the door of the dishwasher and check
if both the tub and door clearances are correct.
If not, rotate the leveling legs on the bottom front
of the dishwasher. You can also check this by
placing a level against an inside front vertical surface
of the tub.
Installing the Dishwasher
If the leveling legs are rotated to the right (counter
clockwise), they are loosened and the front of the
dishwasher is raised. And the maximum height be
raised is about 50 mm. If they are rotated to the left
(clockwise), they are tightened and the front of the
dishwasher is lowered.
CAUTION
Before you move the dishwasher
for installation, make sure to adjust the height
of the legs so the legs are as short as possible.
This prevents the legs from breaking. Level the
dishwasher by adjusting the height of the legs after
you have the dishwasher in place.
When you prepare to move the dishwasher for
installation, you should put your hand under the
basement, this prevents your hand from injuring.
12
Publicité
