Publicité
Les langues disponibles
Les langues disponibles
COMPLETING THE
STEP 12
INSTALLATION
1. Open the door and remove all foam, paper
packaging, and unnecessary parts.
2. Turn on the circuit breaker you turned off before you
began the installation.
3. Open the water supply valve to supply water to the
dishwasher.
4. Turn on the dishwasher, and then select and run a
cycle.
Check if the power turns on correctly and if there is
any water leakage while the dishwasher is operating.
If no errors occur while it is operating, turn off the
dishwasher, and then go to Step 5 below.
If an error has occurred, turn off the dishwasher, close
the water supply valve, and then refer to the user
manual or contact local service center.
Installing the Dishwasher
CAUTION
Make sure to check for water
leakage on both ends of the water supply line and
drain hose connector.
5. Confirm that the kick plate gasket is on the bottom
of the kick plate. To install the kick plate with screw
ST3.9*13, refer to the figure below.
17
Figure 13
Publicité
