GE PBP665SSPFS Instructions D'installation page 14

CONNECTING THE
STEP 10
DRAIN HOSE
1. Check the parts on the sink to which the drain hose
will be connected.
2. There are several ways to insert the drain hose into
the drain hose connector of the sink, as shown in
the following figures. You must connect the drain
hose in accordance with the water pipe installation
regulations in your region.
Case 1. Without disposal
Air gap
Drain hose 2
Hose
clamp
Installing the Dishwasher
Without disposal
Hose
clamp
With an air gap/
without disposal
With an air gap
Figure 7
Case 2. With disposal
Air gap
Hose clamp
3. Check the size of the sink's drain hose connector
(21 mm- as shown in Figure 8 below). If the end
of the drain hose does not fit onto the drain hose
connector of the sink, use an adaptor purchasable at
a plumbing/hardware supply store.
4. Slide a hose clamp over the end of the drain hose.
Attach the drain hose to the sink connector, slide the
hose clamp to the end of the hose, and then tighten
the hose clamp.
Note: You must use a hose clamp. Failure to do so
may cause water leakage.
5. If there is no air gap, make sure to hang the middle
of the drain hose well above the sink cabinet base to
prevent backflow (see Figure 10 on the next page).
14
With disposal
Hose
clamp
Drain hose 2
Disposal with
an air gap
Without an air gap