Publicité
Les langues disponibles
Les langues disponibles
PREPARING THE
STEP 6
DISHWASHER
1. Ensure that the circuit breaker and water supply
valve are turned off before proceeding with the
following steps.
CAUTION
Before you move or lay down
the dishwasher for installation, make sure to adjust
the height of the legs so the legs are as short as
possible. This prevents the legs from breaking.
Level the dishwasher by adjusting the height of the
legs after you have the dishwasher in place.
CAUTION
Do not overtighten the 90° Elbow.
Doing so may damage the water inlet valve and
cause a water leak.
Installing the Dishwasher
2. Make sure there are no kinks and that the hose is not
bent at any extreme angles that could constrict the
flow of water.
3. Remove the junction box cover located at the bottom
front right of the dishwasher using a screwdriver, and
then install the strain relief (Figure 4 - C). Make sure
to keep the junction box cover you removed. It is
used in Step 11, Wiring Connections.
4. If the countertop is made of wood or a material that
is not damaged by drilling, attach the two Installation
brackets that were supplied with the dishwasher
using the supplied screws (Figure 4-A). They will be
used in Step 9 Securing the Dishwasher.
Junction box
Strain relief
10
Figure 4
Publicité
