Publicité
Les langues disponibles
Les langues disponibles
SECURING THE
STEP 9
DISHWASHER
You must fix the dishwasher to the countertop or
cabinet side walls for additional stability and safety
1. If the countertop is made of wood or the material will
not be damaged by drilling, follow the instructions in
2-1 below.
If the countertop is made of granite, marble, or any
other material that can be damaged by drilling, follow
the Instructions in 2-2 below.
2-1. Put a large towel into the bottom of the dishwasher
to prevent wood shavings or a dropped screw from
falling into the dishwasher.
Carefully drill screw holes Into the countertop
bottom by passing the drill bit through a screw hole
in each bracket, and then drilling into the counter
top bottom beneath.
Make sure the hole you drill is smaller than the
diameter of the screw.
First, put the installation bracket into the slot of
the side plane and tighten to the dishwasher with
screw ST3.5*9. Then, insert the provided screws
into the brackets, and finally tighten to secure the
dishwasher to the countertop.
2-2. Put a large towel into the bottom of the dishwasher
to prevent wood shavings or a dropped screw from
falling into the dishwasher. Remove the adjustment
cap with the tip of a screwdriver.
The caps are just inside the tub near the middle of
the tub an both sides (figure 6 below).
Adjustment cap
Screw to side wall
Installing the Dishwasher
Drill a hole into the sides of the kitchen cabinet on
both sides by carefully passing a drill bit through the
screw holes exposed by the removal of the spacer
caps, and then drilling into the cabinet side beneath.
Make sure the hole you drill is smaller than the
diameter of the screw.
Also make sure the drill bit does not strike the
sides of the spacer cap holes. Firstly, put the
installation bracket into the slot of the side plane
and tighten to the dishwasher with screw ST3.5*9.
Then, insert the provided screws into the holes,
and then tighten to secure the dishwasher to the
cabinet. Make sure the tub is not distorted by
pressure from the screws.
If the tub is distorted, loosen the screws a little.
Replace the tub spacer caps.
• The screws or tub spacer cap may fall into the
dishwasher while you are working with the door
open. Cover the interior of the dishwasher with a
towel to prevent any screws from falling into the
dishwasher. If any foreign items such as a screw get
into the dishwasher, it may cause noise, an abnormal
operation, damage, or a malfunction.
• Use a magnetic screwdriver to help prevent screws
from falling into the dishwasher.
• If a foreign item such as a screw gets into the
dishwasher and you are unable to remove it, the
dishwasher needs to be disassembled. Contact a
qualified service technician for this.
13
Figure 5
Figure 6
Publicité
