Publicité
Les langues disponibles
Les langues disponibles
COMPLETING THE INSTALLATION
STEP 12
PANEL READY ONLY
1. Open the door and remove all foam, paper
packaging, and unnecessary parts.
2. Turn on the circuit breaker you turned off before you
began the installation.
3. Open the water supply valve to supply water to the
dishwasher.
4. Turn on the dishwasher, and then select and run a
cycle.
Check if the power turns on correctly and if there is
any water leakage while the dishwasher is operating.
If no errors occur while it is operating, turn off the
dishwasher, and then go to Step 5, 6, 7 below.
If an error has occurred, turn off the dishwasher, close
the water supply valve, and then refer to the user
manual or contact local service center.
CAUTION
Make sure to check for water
leakage on both ends of the water supply line and
drain hose connector.
5. Confirm that the kick panel gasket is on the bottom
of the kick panel. To install the kick panel with screw
ST3.9*13, refer to the figure 14.
Installing the Dishwasher
Figure 14
6. Install the decoration door to the outer door of the
dishwasher.
1) Install the hook and brackets on the decoration
door, see the figure 15.
2) Put the hook into the slot of the outer door, for the
positioning, see the figure 16.
3) Fix the decoration door onto the outer door by
screws and bolts, see the figure 17.
18
Figure 15
Figure 16
Figure 17
Publicité
