Assembling Stand; Mounting Sander To Stand; Handle And Hose Hanger; Infeed And Outfeed Tables (Optional Accessory) - Jet JWDS 2244OSC M Mode D'emploi

Figure 6‐3: Assembly of Sander and OPTIONAL Infeed/Outfeed Tables
6.3 Assembling stand
A closed stand is provided standard with the JWDS‐
2244OSC‐M Sander. Refer to the assembly
instructions that accompany the stand.
6.4 Mounting sander to stand
The closed stand can be oriented with storage door
towards the front or back of machine.
1. Lift drum head assembly out of the box, and
temporarily rest it crosswise on top of stand.
Use an assistant to help lift
the sander.
2. Position sander atop stand so that the threaded
holes of base align with holes in the stand.
3. Fasten base to stand (from beneath) with the 6
provided screws and washers. Tighten screws
securely.
6.5 Handle and hose hanger
1. Install height adjustment handle (B, Fig 6‐3) onto
spindle and tighten set screw.
2. Raise drum and remove shipping block from
between drum and conveyor.
3. Install hose hanger (C) with screws and washers
(C /C ).
1 2
6.6 Infeed and outfeed tables (optional
accessory)
The sander must be bolted to the stand or a work
table when using these table extensions. Maximum
working load of each table is 16kg. Fasteners are
provided with the extension tables.
1. Install infeed and outfeed brackets (F, E, Figure
6‐3) to the threaded holes in sander base with
socket head screws and flat washers (HP4/5).
Make sure left and right brackets are oriented as
shown. The brackets should be flush against the
base. NOTE: Long brackets mount to front
(infeed); short brackets to rear (outfeed).
2. Tighten screws (HP4)
3. Install eccentric cam (HP8) with screw and
washer (HP6/7). Finger tighten only at this time.
4. Install table brackets (G,H), using handles and
washers (HP1/2/3).
5. Place extension tables over brackets and secure
with socket head screws and washers (HP4/5).
Finger tighten only.
6. Position tables slightly below conveyor belt
surface for proper support of stock. To check
position, place a straight‐edge on one side of
conveyor table under drum and extending out
over the extension table.
9