Parkside HG10714 Instructions D'utilisation Et Consignes De Sécurité page 17

you feel resistance.
Ensure that you do not damage the depth-
measuring blade
measure by exerting too much pressure on them.
The LCD display
After measurement:
After carrying out the measurement, move the
external measuring jaws
jaws
[ 2 ]
inwards clockwise.
[ 7 ]
Switch the LCD display
the ON / OFF key
Tip: The LCD display
itself off after approx. 5 minutes.
Tighten the locking screw
clockwise until you feel some resistance.
˜ Examples of use
Tip: When measuring, always proceed as described
in the chapter on using the caliper.
Comparison of plug and socket (see Fig. C):
First measure the dimensions of the plug
(see Fig. C.1).
You may wish to make a note of the
measurement.
Then, measure the socket (see Fig. C.2).
Deviation from a reference value
(see Fig. D):
Measure a reference object (in this case A)
(see Fig. D.1).
Leave the measuring jaws
and press the key to obtain the zero setting
(ZERO)
Then measure the second object (see Fig. D.2).
The LCD display
the measurement of the second object to that of
the reference object (A).
14 GB/IE/NI
6 ] [
5 ] [
together again by turning the handwheel
10 ] [
.
9 ] [
5 ] [
or the object you want to
now displays the dimensions.
/ internal measuring
11 ] [
off again by pressing
5 ] [
.
automatically switches
5 ] [
again by turning it
4 ] [
/
2 ] [ 11 ] [
now shows the deviation of
in this position